Residential Roofing in Millersville
Millersville's housing stock is a mix of 1970s and 1980s colonials, 1990s subdivisions, and newer builds off the Benfield corridor. Most of the homes we work on have steep roofs, mature trees, and original flashing that is past its service life. Families here care about two things: stopping leaks before they stain the ceiling, and getting a roof that will not need replacing again in 15 years. We handle both with the same crews, and we do not subcontract residential work to day labor.
- Full roof replacement — Most Millersville replacements are second-layer tear-offs on homes built between 1975 and 1995. We strip to the deck, replace any soft sheathing, install ice and water shield at the eaves, and finish with GAF or Owens Corning shingles. A standard house takes one to two days, and we haul the old shingles out the same day.
- Leak diagnosis and repair — Leak calls in Millersville almost always trace to flashing, not the shingle field. We use a moisture meter to find the actual entry point instead of guessing, then repair the step flashing, pipe boot, or valley that failed. Most repairs finish in under three hours and cost $450 to $1,200.
- Storm damage assessment — After a hail or wind storm, we inspect the full roof, document damage with photos for your insurance adjuster, and handle the supplement paperwork. We replace bruised shingles, damaged ridge vent, and lifted flashing. Millersville sits in a corridor that catches summer storms, so this is a big part of our residential work.
- Attic ventilation and ice dam prevention — Ice dams form when attic heat melts snow that refreezes at the eaves. We check attic ventilation during every inspection and replacement, and we install ice and water shield at the eaves to stop water backup. If insulation is blocking your soffit vents, we tell you so you can fix the root cause, not just the symptom.
